A “4A” gate-driver rating can be misleading if it is compared directly with a MOSFET’s load current. When buying UCC27517ADBVR, establish how the driver charges and discharges the gate and whether it suits the circuit. The 4A figure is not the rated output current of a motor or power supply.
Turn the 4A specification into a sourcing check
Item | Evidence to request | What it does not replace |
|---|---|---|
MOSFET gate | Full code, Qg at stated conditions and allowed VGS | Drain-current rating does not define gate demand |
Driver supply | Actual voltage range, decoupling and startup conditions | Controller logic voltage is not gate-drive voltage |
Power stage | Frequency, measured waveforms and temperature rise | 4A peak does not validate continuous operation |
Confirm the device type and complete ordering code
TI identifies UCC27517A as a single-channel low-side gate driver with 4A peak source and sink capability and a 4.5–18V supply range. UCC27517ADBVR uses the 5-pin DBV SOT-23 package. Read peak specifications with their manufacturer test conditions; they do not describe a continuous 4A power supply.
How does peak drive relate to MOSFET load current?
The driver moves charge into and out of the MOSFET gate during switching. The controlled power current flows through the MOSFET’s main circuit. These are different paths, so matching current numbers does not establish suitability.
Engineering should evaluate gate charge, target transition time, drive voltage and loop impedance. Procurement can request the full MOSFET code and approved driver code instead of proposing substitutes from the MOSFET current rating alone.
A calculation buyers can understand
For illustration only, assume a switch has 40nC total gate charge under specified conditions and operates at 100kHz. The estimated average gate-charging current, Qg × f, is 4mA. That does not mean the instantaneous demand is only 4mA or that driver heating is negligible. Switching waveforms, driver losses and power-switch losses still require engineering validation. These assumed values are not a measured result for UCC27517ADBVR paired with an arbitrary MOSFET.
Low-side and high-side drivers need different checks
A low-side circuit has a different reference arrangement from a floating high-side circuit. If the project drives a high-side switch, ask engineering to confirm the topology and required driver structure. Another five-pin driver is not automatically suitable for the same board.
Logic-input voltage and gate-drive voltage are also separate checks. Record the controller logic level, driver supply and MOSFET gate-source limits before sourcing samples.
What should a sample evaluation cover?
Gate waveforms, overshoot and ringing on the actual PCB, using a measurement method suitable for the circuit.
Driver and MOSFET temperature rise at the intended frequency, load, supply and ambient conditions.
Output behavior during power-up, power-down and control-signal changes.
Engineering review of gate resistors, decoupling and routing, with the approved configuration recorded.
These are validation-planning suggestions. The project determines test methods and acceptance limits. A running sample does not complete validation of all production operating conditions.
Keep these details in the RFQ
Specify UCC27517ADBVR in full, sample and production quantities, requested arrival date, packaging and lot requirements. Treat a proposed change among UCC27517, A or Q1 variants as a separate document and engineering review, rather than an already validated replacement.
View the UCC27517ADBVR product page or use the WOMAiELEC inquiry page to confirm supply terms. Displayed prices and quantities require supplier confirmation. Agree on packaging, inspection records and quotation validity in the purchasing process.
Manufacturer references
TI UCC27517A datasheet; TI UCC27517ADBVR ordering details. Sources reviewed November 14, 2026.
